Type III bursts are among the strongest radio signals routinely observed by both space-borne and ground-based instruments. 
© Krupar et al. (2020) | Density fluctuations in the solar wind based on type III radio bursts
They are generated via the plasma emission mechanism, when beams of suprathermal electrons interact with the ambient plasma, triggering radio emissions at the plasma frequency (the fundamental emission) or at its second harmonic (the harmonic emission). As the electron beams propagate outward from the sun, radio emissions are generated at progressively lower frequencies corresponding to a decreasing ambient solar wind plasma density. Type III bursts can be simultaneously detected over a broad range of longitudes, and their radio sources lie at considerably larger radial distances than predicted by electron density models.
These obscure properties are often attributed to the scattering of radio waves by electron  inhomogeneities. The Parker Solar Probe (PSP) spacecraft, launched in August 2018, is a project of NASA to probe the outer corona of the sun. Its main science goal is to determine the structure and dynamics of the sun's coronal magnetic field, understand how the solar corona and solar wind are heated and accelerated, and determine which processes are responsible for solar energetic particles. A new study reports on a statistical survey of type III burst  times and in-situ density fluctuations measurements.
The researchers analyzed a large number of type III bursts observed by PSP during the perihelion No. 2 in order to statistically retrieve their exponential decay times as a function of frequency (Figure 1a). During this period, radial distances from the sun ranged from 35.7 to 53.8 solar radii. Krupar et al. (2018) performed a similar analysis of 152 type III bursts between 125 kHz and 1 MHz observed by the STEREO spacecraft located at 1 au. The obtained spectral index is about two times smaller than for PSP.
The researchers note that a plasma frequency of 1 MHz—where the slope changes between STEREO and PSP—corresponds to a radial distance of eight solar radii, where the solar wind speed typically exceeds the Alfvén speed, and the solar wind becomes super-Alfvénic. It is thus no surprise that type III burst properties change around a frequency of 1 MHz as the background plasma changes significantly. The scientists note that type III bursts also exhibit a maximum of power spectral density at 1 MHz.
They implemented a Monte Carlo simulation technique to study the role of scattering to decay times. From arrival times, they calculated the decay times and compared them to those observed by PSP. The results suggest that the exponential decay of the observed power spectral density can be explained by the scattering of radio signals by density inhomogeneities in the solar wind. The relative electron density fluctuations were 0.09-0.22 at the effective turbulence scale length (Figure b).
In summary, type III burst decay times between 1 and 10 MHz are statistically longer than expected based on previous observations at . This can be explained either by different ambient  parameters above the Alfvén point or because the harmonic component above 1 MHz was preferably observed. If the latter is true, variations in exponential decay times can be used to distinguish fundamental and harmonic components within one single type III burst. By comparing PSP observations and Monte Carlo simulations, the researchers predicted relative density fluctuations at radial distances between 2.5 and 14 solar radii to range from 0.22 and 0.09.

This article was originally published by the Community of European Solar Radio Astronomers.
Previous Post Next Post